How to resolve printer repair infusion colds

How to resolve printer repair infusion colds- Not only people who can get in the wind, a printer could also. This term is not foreign to the infused printer. Said to be cold if the IV tube contained air cavity, which causes the interrupted supply of ink flow from the infusion tube to the cartridge.

Indication that a cold infusion printer is characterized by an air cavity on the IV. In normal conditions, channel IV tubes filled with ink / no air cavities in the IV. Although the printer is dicleaning / deep cleaning (on printer canon), the air cavity missing only a few moments, then reappeared air cavity.

Cause of colds infusion printer, due to the incoming air on the channel infusion system printer. The cause is not only one, can be a variety of causes, but from experience is often the case, the incoming infusion printer caused by:

infusion parts printer parts

- Hose infusion leaked, could be due to injury pinched, cutter accidentally cut during installation, etc.
- L-knee leak
- Rubber neple tear
- The hole in the cartridge is too large infusion
- Cartridge broken / connection on the cartridge cover is not attached

Solutions to cope with colds printer, not just one way, depending on the cause of the problem as well. Here are the steps based on the cause:

Step one: Check one by one and fix the printer cause the infusion part colds.
- Hose leaking infusion
Physical checks along the IV printer does have a leak / injury / chipped, starting from the infusion tube to the cartridge.
Fix / patch if something is broken / leaking, if not impossible, can not be repaired replace with a new IV.
- L-knee leak
Check using injections are connected with a hose.
Replace with a normal if leaking
- Rubber nepple
Remove the check from the cartridge, if it is defective mortar or replace with good ones.
- The hole in the cartridge is too large infusion
If the hole is too big infusion, there are two alternatives: 1. close the hole is too big then make a new hole to the size that fit. 2. L-gluing rubber knee and nepple directly on the cartridge hole.
- Cartridge rupture
Checks looking catridge part that broke, usually on the cartridge cover is not attached to the connection.
Fix / glue on a broken piece cartridge, make sure no air that entered.

Step two: If you do a "first step" and certainly no part of the channel infusion system is broken / leaking, then the next step is to remove part of the air cavity at the IV.
There are several ways to do it, but here discussed 3 ways to eliminate air voids in the IV printer.

how deep the printer head cleaning

1. Using a dry application default printer driver. Deep Cleaning in Canon printers and Head Cleaning on Epson printers. Weakness of this method, needs to perform repetitive if the air cavity in the hose is too long.

injection and hose colds printer service tool

2. Using injections which are connected with a hose, how to remove the L-knee on the cartridge (if not glued) then connect the hose from earlier injections, then suck on the hose to the air cavity is lost.

Toolkit service tool vacuum cartridge

3. Using the toolkit vacuum cartridge, how to install tools later toolkit vacuum suction using an injection cartridge, until the air cavity in the IV lost

Judul: How to resolve printer repair infusion colds
Ditulis oleh Unknown
Rating Blog 5 dari 5